The Tevo Tornado is in my opinion a quite good printer out of the box, however there are some things that can be upgraded very easy that help raise quality reliability and safety.<\/p>\n
The leveling nuts on the Tornado are small and it is difficult to level the bed, this makes it easier.<\/p>\n
https:\/\/www.thingiverse.com\/thing:2636745<\/a>\n <\/li>\n The power cables of the heat bed are connected to mains voltage this helps protecting the cables from movement stress. Later i replaced this with the ultrabase mount.<\/p>\n https:\/\/www.thingiverse.com\/thing:2748197<\/a>\n <\/li>\n The “Build Tac” sheet from Tevo is quite good but is damaged quickly when trying to remove parts that stick very well, for that i decided to replace it with a 310x310mm anycubic ultrabase and used these mounting brackets. For the horizontal profile to guide the cables going to the hotend.<\/p>\n https:\/\/www.thingiverse.com\/thing:2819734<\/a>\n <\/li>\n Helps to fine adjust Z height very easy.<\/p>\n https:\/\/www.thingiverse.com\/thing:2805228<\/p>\n <\/a><\/li>\n https:\/\/www.thingiverse.com\/thing:2795109<\/a>\n <\/li>\n https:\/\/www.thingiverse.com\/thing:2788574<\/a>\n <\/li>\n Link to the thing will follow.\n <\/li>\n The coupler installed on the Tornado is not the best and can cause wobbling. I replaced it with this design.<\/p>\n https:\/\/www.thingiverse.com\/thing:602481<\/a>\n <\/li>\n https:\/\/www.thingiverse.com\/thing:2562736<\/a>\n <\/li>\n Reminds you in which direction to turn.<\/p>\n https:\/\/www.thingiverse.com\/thing:2670912<\/a>\n <\/li>\n https:\/\/www.thingiverse.com\/thing:2766637<\/a>\n <\/li>\n https:\/\/www.thingiverse.com\/thing:2783077<\/a>\n <\/li>\n https:\/\/www.thingiverse.com\/thing:2790738<\/a>\n <\/li>\n https:\/\/www.thingiverse.com\/thing:2754529<\/a>\n <\/li>\n https:\/\/www.thingiverse.com\/thing:2759439<\/a>\n <\/li>\n https:\/\/www.thingiverse.com\/thing:2780438<\/a>\n <\/li>\n https:\/\/www.thingiverse.com\/thing:2791184<\/a>\n <\/li>\n<\/ol>\n 19. Dual Z lead screw with single motor<\/p>\n https:\/\/www.thingiverse.com\/thing:2668969<\/a><\/p>\n","protected":false},"excerpt":{"rendered":" The Tevo Tornado is in my opinion a quite good printer out of the box, however there are some things that can be upgraded very easy that help raise quality reliability and safety. Level Knobs The leveling nuts on the Tornado are small and it is difficult to level the bed, this makes it easier. … Continue reading Upgrades i made to my Tevo Tornado<\/span>
\n
\n https:\/\/www.thingiverse.com\/thing:2801756<\/a>\n <\/li>\n